Scotch Porter Beard Tools Collection: boar bristle brush and Kent beard combs for shaping a beard

How to Shape a Beard: A Step-by-Step Guide for Coarse, Curly Beards

By the Scotch Porter Team · 8 min read

Man with a full, coarse, freshly shaped beard

Here's how to shape a beard: start with a clean, conditioned beard, comb it out to full length, set your neckline and cheek line, trim the bulk with the grain, clean up the edges, then lock the shape in with balm or wax. On a coarse, curly beard, the prep and the finish matter as much as the trim. Our picks for the job are the Kent Large Beard Comb, our Boar's Beard & Hair Brush, Beard Balm and Styling Wax. Yes, we make them, so we'll tell you exactly how to use them.

Sharp for a day, then puffed out? Textured beards shrink, coil and grow at different angles, so shaping one takes a few extra steps.

Below we cover the prep, the lines, the trim, the line-up, and how to keep the shape holding all day. Picking a style first? Start with our guide to your perfect beard style.

Why textured beards need a different approach

Coarse, curly hair doesn't sit where you cut it, because it springs back as it dries. Here's what that means for shaping.

  • Shrinkage hides length. A coiled beard looks shorter than it is. Trim it wet and stretched, and it can spring up far shorter than you meant once it dries.
  • Growth goes every direction. Textured beard hair often grows at several angles on the same cheek. If you skip the comb-out, you won't find the uneven patches until the trim is done and it's too late to fix them.
  • Dry hair is harder to shape. Soft, moisturized hair lies down and holds a line much longer than dry hair does.
  • Tight curls can grow back in. Sharp edges and close shaves make it easier for curly hairs to curve back into the skin. That's why aftercare is part of this guide.

How to shape a beard, step by step

Give yourself 20 minutes, good light and a mirror where you can see your whole jaw from the side. Do a full shape every two to four weeks and a quick edge-up in between.

Step 1: Prep the beard before you cut

  1. Wash. Use Moisturizing Beard Wash to clear oil and buildup two to three times a week.
  2. Condition. Follow with Hydrate & Nourish Beard Conditioner to soften and detangle. Here's what beard conditioner does.
  3. Towel-dry. Pat, don't rub. For the trim itself, let your beard dry fully, so you're cutting it at its true, everyday length.
  4. Comb out. Work the Kent Large Beard Comb from the ends up toward the skin, then from the skin out. Comb down and slightly outward to see where it's uneven.
  5. Brush. Finish with the boar bristle brush to smooth the surface and set the direction.

Step 2: Find your neckline

Your neckline does more than anything else to make a beard look groomed.

  • Place two fingers flat above your Adam's apple, and where the top finger sits is the center of your neckline.
  • From there, picture a soft U-shaped curve back to just behind each earlobe.
  • Shave everything below that curve.

Set it too high and your beard looks smaller from the front and the side, so start low. You can take more off next time.

Step 3: Set your cheek line

Your cheek line runs from the top of your sideburn to the corner of your mustache. You've got two options:

  • Natural. Follow where your hair grows and only clean up the strays above it, which works best when your cheek growth is already even.
  • Defined. Draw a straight or gently curved line from sideburn to mustache, keeping it at or just below your natural line. Drop it too low and the beard looks thin from the side.

Step 4: Trim with the grain

Comb the hair out, then take length off in small passes, following the direction your hair grows. Start with a longer guard than you think you need.

  • Keep the sides slightly shorter than the chin for a clean, structured shape.
  • Trim the mustache line with scissors over a comb, along with any single strays the trimmer misses.

How to line up your beard

A line-up is the crisp edge on your cheek line, neckline and around the mouth. It's what makes a textured beard look fresh.

  1. Start with a clean, dry face and your beard combed into place.
  2. Outline first. Lightly trace the line with your trimmer before you commit, so you can check it in the mirror.
  3. Edge with the grain. Use short, light strokes in the direction of growth. Pulling the skin tight or going over the same spot again and again is what sets up irritation.
  4. Match both sides. Use a fixed point, like the corner of your mouth or the top of your ear, to keep both cheek lines level.
  5. Don't chase perfect. Every extra pass moves the line a little higher, so stop as soon as it looks clean.

Beard shaping tips by face shape

Use the beard to balance your face shape, and treat the table below as the short version.

Face shape Shape to aim for Keep in mind
Oval Almost anything works: short boxed, full or stubble Keep the sides and chin even so you don't lengthen the face
Square Fuller on the chin, shorter on the sides A rounded neckline softens a strong jaw
Round Length at the chin, tight on the cheeks Angular cheek lines add definition
Long or oblong Fuller on the sides, shorter at the chin Avoid a long, pointed chin

Want the full breakdown? See our guide to your perfect beard style or the best short beard styles for all face shapes.

How to hold your beard's shape all day

A fresh shape lasts a lot longer when the hair is soft and has a little hold to it. Balm goes on first, then wax wherever you need more control.

  1. Balm. Warm a small amount of Beard Balm between your palms and work it through to the ends. It seals in moisture and adds light hold for flyaways. Here's how to use beard balm.
  2. Oil (optional). If your beard runs dry, add a few drops of Beard Oil on top of the balm.
  3. Comb into shape. Use the Kent Large Beard Comb to set the direction: down and slightly forward on the cheeks, down on the chin.
  4. Brush. The boar bristle brush smooths the surface and trains coarse hair to lie in place over time.
  5. Wax for detail. A small amount of Beard & Mustache Styling Wax, warmed between your fingertips, holds the mustache, the edges of the cheek line and any strays that won't stay down.

Should you comb your beard up or down? Comb down to finish. Combing out is for before a trim; a finished beard looks neatest combed the way it grows.

If you add the oil, you also get its warm spice and powdery musk, so you smell as good as you look.

Scotch Porter Beard and Mustache Styling Wax for holding beard shape

The Scotch Porter beard shaping kit

Kent Large Beard Comb

Use it to stretch a coarse beard out and see its real shape before you trim, working from the ends up so it doesn't snag.

Shop Kent Large Beard Comb →

Boar's Beard & Hair Brush

Brush through after balm or oil to spread it evenly, and over time coarse hair learns to lie the way you set it.

Shop Boar's Beard & Hair Brush →

Beard Balm and Styling Wax

Use the balm for everyday hold and the wax for the mustache and edges. Beard Balm has 4.9 stars from 2,395 reviews.

Shop Styling Wax →

Beard Tools Collection

It puts our grooming tools in one set: the Boar Bristle Beard & Hair Brush, the Kent Large Beard Comb and the Kent Pocket Beard Comb, so you can prep, shape and touch up at home or on the go.

Scotch Porter Beard Tools Collection for shaping and grooming a beard at home

Shop Beard Tools Collection →

After the line-up: razor bumps and when to see a dermatologist

Razor bumps, or pseudofolliculitis barbae, happen when a cut curly hair curves back into the skin and causes red, tender bumps. They're common: a 2019 review in the Journal of Drugs in Dermatology cites a study putting the rate among Black men at 45% to 83%.1 Fresh edges and close shaves are a common trigger, so go with the grain and don't over-shave one spot.

Got bumps after a fresh line-up? That's what our Anti-Bump & Ingrown Roller is built for. Its fragrance-free formula pairs salicylic acid and willow bark extract, which gently exfoliate to help free trapped hairs, with aloe and allantoin to calm redness and irritation. Roll it over the line-up on clean, dry skin after you shave, daily until bumps calm, then as needed. As one verified buyer, Robert, put it: “Only product that has ever prevented my razor bumps.”

For a full post-trim routine, read post-trim skin that holds up in real life.

Scotch Porter Anti-Bump and Ingrown Roller for razor bumps after a beard line-up

The roller won't treat infection or scarring. If bumps are painful, keep coming back or leave dark marks, see a board-certified dermatologist.

FAQ

How do I shape my beard at home?

Wash, condition and let your beard dry before you comb it out. Set your neckline two fingers above your Adam's apple and your cheek line from sideburn to mustache. Trim with the grain using a long guard, clean up the edges, and finish with beard balm and a brush to hold the shape.

What is the 3-month beard rule?

It's common advice to let your beard grow for about three months before you shape it seriously. That gives slow and patchy areas time to fill in, so you can see your real shape before you cut anything off. In the meantime, keep the neckline tidy and the beard moisturized. Thin spots? See how to fix a patchy beard.

Should a beard line be straight or curved?

Both work. A gentle curve that follows your jaw looks natural on most faces and grows out more cleanly, while a sharp, straight line looks bolder and needs touching up more often. On the neck, go with a soft U-shaped curve from behind each ear.

How do you line up under a beard?

Find the point two fingers above your Adam's apple, then trace a soft curve from there to just behind each earlobe. Remove everything below that line with short strokes in the direction of growth. Start low and work up slowly, since a neckline set too high makes the beard look smaller.

How do I stop my beard from looking scraggly?

Keep it moisturized, combed and lined up. Dry, coarse hair frizzes, so wash two to three times a week, condition, then use beard balm and a boar bristle brush daily. Touch up the neckline and cheek line every week or two, and use styling wax on stray hairs.

Keep the shape between trims

Comb it out, set the lines, trim with the grain and hold it. Between trims, a couple of minutes each morning with the comb, brush and balm is what keeps the shape where you put it.

Shop Beard Products →

Keep reading

Sources

  1. Journal of Drugs in Dermatology, 2019 review of pseudofolliculitis barbae: https://jddonline.com/articles/dermatology/S1545961619P0246X
Back to blog